Trusted Waterproofing Company Serving Longview, WA

This home had settled, and had caused some of the wooden posts to shift. Three of the posts no longer sat properly on their footing, and the home's floor was warped a bit because of this. They wanted to protect their home, so they called up John's Waterproofing for some structural repair and some general preventative waterproofing. 

To begin, our crew pulled out the general debris from under the home. We then installed four SmartJacks through the crawlspace. This will not succumb to any water issues and can be adjusted if needed in the years to come. We then dug a trench around the interior perimeter, where we installed a perforated pipe in a silt sock. This will collect groundwater and grade it to a newly installed SuperSump Plus in the lowest spot. This then pushes all water safely out and away from the home to a LawnScape outlet. We then laid down a new 6 Mil vapor barrier. This is overlapped throughout the crawl space and run up the foundation walls to help this space dry and healthy. 

This homeowner suspected that some cleanup and repairs might be needed for her crawlspace, so one of our Design Specialists was scheduled to go take a look.  Once there, he thoroughly examined the crawlspace and recommended a full encapsulation for its advantages in health and for the home.

After arriving a few weeks later, our crew got right to work and removed the damaged 6 mil vapor barrier, fiberglass insulation, and debris. They installed a 3" perforated pipe drainage system around the perimeter to collect the ground water and direct it to a newly installed TripleSafe sump pump, along with proper discharge. TerraBlock, a high-density foam product was laid over the dirt floor. This aids in insulating the crawlspace, protecting the new CleanSpace, 20mil, nylon-reinforced barrier. This is used to isolate each wooden post and anchored to the foundation walls. Lastly, a SaniDry dehumidifier was installed to ensure this home stayed dry and healthy. With all the vents sealed, Spray Foam insulation was applied to the full wall of the foundation to keep the home insulated and keep the air clean and free of mold.

This home had high energy bills, and without any insulation in their unfinished basement, this was a great place to start to take control over heating and cooling costs. To ensure the job was done right, the homeowners called John's Waterproofing. 

Our crew arrived and began by digging a trench along with the interior parameter and installing a WaterGaurd drainage system. This would collect water and divert it to a newly installed TripleSafe Sump pump. We then covered the walls with our ThermalDry wall panels, this would help control the home's temperature, and was then covered in our BrightWall panels to give the space an easy to clean, bright unfinished look. This home saw their energy savings that very same month, and they could feel the difference as well. 

This basement had been finished, their basement had fully installed drywall and carpeting throughout. While this had been done well, the contractors who had done the work, never added in any waterproofing solutions. Some of the rooms were beginning to experience water mold coming through the drywall and they had sections of the carpeting that would get water saturated when there was heavy rains. They wanted to keep using their basement, so they called John's Waterproofing. 

Our crew came out and had to remove the interior Drywall sections of the basement as well as pull up all of the carpeting. We then dug down along the interior walls and installed WaterGuard piping to take all of the water to a newly installed SuperSump that would take all of the water and discharge it a safe distance away from the homes foundation. We then installed a ThermalDry wall radiant vapor barrier which keeps the homes heat in and water out. The floor was then covered in ThermalDry Carpeted Floor Tiles which would work to keep water out of the basement. Once we finished the basement was fully waterproofed and ready to be refinished.