Addressing this Crawl Space Before Sale in Snohomish, WA

These homeowners were looking to put their home on the market but found a lot of problems in their crawl space. They knew that if these issues was not addressed properly - it would cause problems with the sale. Encapsulating the crawl space not only helps with the air quality in the home, and to reduce energy bills but it can help over all increase the home value. These homeowners wanted to make sure that this problem was permanently solved so they called up John's Waterproofing for a free visit. Our Real Estate Response team went out to thoroughly inspect this crawl space and come up with the best plan to create a dry, healthy and stable home to confidently place it on the market. We start this project by removing all of the debris, fiberglass insulation and old vapor barrier. We then removed one of the damaged wooden beams and replace it with a steel beam. Then, since there was some problems with the floors sagging, we replaced the weak and damaged wooden posts with our SmartJack system. These will provide secure and stable support as well as lift up the floor. Next we dig a trench around the interior perimeter of the crawl space in which we place a 3 inch perforated pipe into a silt sock to secure a safe passage for water to drain to the lowest point. Then, at this low point we install our SuperSump Plus. This system will pump all of the water that enters outside and away from the foundation through a discharge line. We then cover all of the vents to seal them permanently from the outside to stop unwanted air from entering the crawl space. Following this, we install TerraBlock onto the dirt floor, creating an insulated barrier between the home and the earth. On top of the TerraBlock we install CleanSpace. This is also anchored into the foundation walls up to the rim joists, and inserted between each footing and post. To control the environment, we install or SaniDry Sedona Dehumidifier that will effectively eliminate damp and musty odors while keeping the home at a healthy relative humidity. Lastly, to finish, we spray our foam insulation directly onto the foundation walls up to the rim joists. This process will fill every crack and void guaranteeing a complete airtight seal. Now that this home is fully encapsulated, these homeowners can be sure that their home will be safe for the next owners.