John's Waterproofing Before & After Photos

When a neglected area such as a crawl space gets water intrusion, it can create moisture that leads to mold and mildew growth. This will begin to affect the air quality in the home, damage the fiberglass insulation and create wood rot, damaging the structural integrity of the home. During this crawl space inspection we found mold on the subfloor and had the right solution in mind. Soda Blasting is an eco-friendly way to remove mold. This process uses compressed air to spray sodium bicarbonate (baking soda) and physically removes the mold and deodorizes the surfaces, leaving the subfloor clean and free of mold without causing any structural damage. Before installing the full encapsulation that this crawl space needed, we properly seal off the crawl space from the home to prevent baking soda from going up into the home and we then use our soda blasting machine to spray the areas with mold until it is looking brand new. Now that this mold is removed, we can then install our full encapsulation that will help in protecting this crawl space from any future mold growth. 

This customer called complaining that they had water leaking thru the foundation and wall of their finished basement. We installed our patented WaterGuard system and TripleSafe sump pump. 

This customer called because they had a musty smell coming into their home from their crawlspace. The crawlspace was dusty, had some moisture on the vapor barrier, and had a strong musty smell. Our crews went in and encapsulated the crawlspace using our CleanSpace Vapor barrier. It is 20 mils thick and is rip resistant to keep animals and bugs out. We also installed our SaniDry Sedona dehumidifier to help keep the moisture out of the crawlspace and filter the air. After encapsulating the crawlspace the homeowner was so relieved that they didn't have a musty smell coming into their home. 

The customer called due to concerns on a small vapor barrier covered crawl space in the basement. There were a very strong musty smell and moldy shelves that were next to it, which were also raising red flags. We encapsulated the small crawl space and got a dehumidifier down in the daylight basement to regulate any unforeseen future humidity problems. 

Concrete walls are naturally porous so they tend to act as hard sponges. Absorbing moisture from the surrounding soil and leading to high levels of indoor humidity. This can cause issues with mold, efflorescence and structural damage. The paint on the concrete walls in this basement were peeling and cold to the touch which was also an indication of moisture intrusion. These homeowners reached out and set up their free visit. we went out and thoroughly inspected this basement and came up with our best options for these homeowners so this basement could transform into a dry, stable and healthy space.

We began by creating a trench around the interior perimeter of this basement using a jack hammer, in the trench we add clean gravel rock and our WaterGuard drainage system on top to collect water from the walls and groundwater and direct it to the lowest point. Then this system gets concreted over, level with the floor. At the low point we install our SuperSump Plus to gather the water that enters and pump it outside of the home, away from the foundation. This home had several below below grade windows, for each, we install a WellDuct to direct water from the window well inside into the perimeter drainage system. On the porous concrete walls, we install our BrightWall system which will also help guide any moisture down into the WaterGuard system while providing a semi-finished look for this basement. The final piece was the dehumidifier which helps the space maintain healthy air, removing the excess moisture. Now, with this system in place these homeowners can have peace of mind.