John's Waterproofing Before & After Photos

This homes basement was going to be finished. To do so the homeowners knew they would need to waterproof first. There was already water creeping in along the corners and knew if they finished, the water would become an expensive issue. To waterproof and prep the space we installed a full interior drainage system, a Sump pump, and ThermalDry radiant wall barrier. Our electrician division then went in the set up the electrical aspects of the home so it will be ready for the homeowners chosen contractor to finish. 

This homes crawl space had a good slope, and the water would pool in the lower areas, causing damp odors. To address this issue the homeowner called up John's Waterproofing to get a quote to replace the 6 Mil. We ended up installing a pipe system to ensure water was directed to the lowest point where a new TripleSafe sump pump is installed and we installed a new 6 Mil vapor barrier, overlapping edges and running it up the walls to help it last a few years until the barrier will need to be replaced or upgraded again. 

This wall had a hairline crack and was beginning to break down the structural integrity. Our team went in and put in power braces to help hold the wall and they are then going to finish the wall. 

This homes crawlspace had an old 6 Mil vapor barrier, and after a few years, these need to be changed out. They dont fully seal a space, and can move around over time. This one had been installed a little over six years ago, and some chew marks were present, bringing water over the barrier, and humidity issues were causing the homes insulation to sag and fall in places. To keep the home healthy, the homeowners opted to have a full encapsulation solution installed, providing their home with a long term solution. 

This crawlspace had mud caked throughout, to control the water issues present we did a crawlspace encapsulation.